Good morning Sir
Thank you so much.
Ok, I have done the connection on a breadboard for now. But still having wrong values with the ecgData and the outRR. Talking of the heartbeat rate, it is varying between 60-72 bpm .
But was wondering about my connection , I have only connected the 6 pins on the left of the ECG 3 click (from GND to CS) to the STM32F446E , I have not touched the right side. Is it the right connection ?
In addition, I have noticed that the output generated by the terminal or console stops generating after 4 or 5 minutes . Why is it like that please ? is it not supposed to continuously generate till I decide to disconnect my board ?
Thank you .