Hi, The problem I am facing is quite weird but seems real. When I connect STM32F429ZI to a radio we developed around CC1310 from TI via UART, I noticed that after flashing new firmware into STM32F429ZI or a cold start, I have to reset CC1310 to get UART communication between those two, specifically…

The problem was tracked down to glitch on UART RX line on CC1310. When STM32Fxxx with Mbed resets. I assume RX line is briefly pulled down therefore CC1310 thinks some data is going to be transmitted, while there is no actual data. Such glitch was not properly handled by either CC1310 hardware, driv…

What could go wrong when connecting UARTto MCUs from other vendors and running differentstack?

Mbed OS

JohnnyK (Jan Kamidra) February 11, 2022, 7:08am 3

Hello,

Can’t it be related to this? STM32 : full GPIO reset during mbed init.

BR, Jan

Topic		Replies	Views
MTB_MURATA_ABZ USB and Serial Support Mbed OS usb-device , murata	2	535	April 19, 2020
SPI is locking up the MCU? Bugs stmicroelectronics	0	160	September 23, 2020
I2C issues with STM32F303K8 Platform specific questions mbed_os , stmicroelectronics	1	1302	December 21, 2020
STM32L432kc using both SPI modules Mbed OS stmicroelectronics	1	167	May 7, 2022
Error on Nucleo F446RE "The interface firmware FAILED to reset/halt the target MCU" Boards stmicroelectronics , nucleo-f446re	6	2774	February 18, 2023

What could go wrong when connecting UARTto MCUs from other vendors and running differentstack?

Related Topics