Pyocd errors on programming and debugging of STM32F746

[JohnnyK (Jan Kamidra)]

Hello,

I can agree that but this target was silently removed from the list of supported boards for debug.

Can't debug Nucleo L432KC (supported board)

Hello, just for clarification. Do you have the Mbed Studio and its modules updated? I have the USB-symbol green and I can press the debug button but after the session start, it is ended immediately. My setup: MbedStudio 1.3 on Windows10 (St-link firmware V2J37M26). Nucleo-L432KC - description above - “…exit code 1” Disco-F746NG - “No cores were discovered!” Nucleo-F767ZI - working @arekzaluski any recommendation? BR, Jan

BR, Jan