Not Recognizing the B-L475E-IOT01A2 board

I am using B-L475E-IOT01A2.
It was working without any problem in the old MBED Studion,
but seems to be not working properly in the KEIL MBED Studio.
Besides, the B-L475E-IOT01A-2 is not included in the armKEIL list ,
although the B-L475E-IOT01A-1 is in the list as you can see belows.
Any problem ? Discarded ?


it is Keil Studio Cloud and not KEIL MBED Studio, and also could be more eficient to place this to Keil Studio forum section instead of Mbed Studio section.

The Mbed Studio was not updated for a while compared to Keil Studio Cloud. So maybe is necessary to make firmware update of STLink.

In other hand, it seems like Mbed OS does not make difference between 1 and 2, because the main difference should be a frequency of the on-board radio - The A1 has a 915 MHz Sub-GHz radio, while the A2 has the 868 MHz radio - DM00347848 page 8 (probably US/EU).

So when Mbed Os does not make difference between these two versions, then also Keil Studio Cloud / Mbed Studio can not do this.

BR, Jan

I agree, tools doesn’t make the difference between A1 and A2.
You should probably update the STLink FW version: mbed-os/targets/TARGET_STM at master · ARMmbed/mbed-os · GitHub

Good. I ungraded the USB driver in the STSW-LINK009 and the ST-Link FW in the STSW-LINK007.
And It’s working as I expected now as shown below.
Thank you very much.