Problem the Nucleo F401RE board

Mbed OS Hello world!
,
1

Hello my friends, I’m trying fleshing programming my Nucleo board abrow “STM32IDE”, but it’s not work. Message is “Error in initializing ST-LINK device. Reason: No device found on target”. Messag in FAIL.txt is “The interface fimware FAILD to reset/halt the target MCU”. I’m trying update fimware abrow “STM32CubeProgrammer” and connect nucleo, but is not success.

Do you know what is the problem ?

Thanks a answer!

2

Unless you disconnected the ST-Link and the STM32 chip on the board, this error likely means you have a dead board sadly.

3

I solved the problem by connecting my board from STMCubeProgrammer and updating the firmware.