Pyocd errors when debugging on NUCLEO-F746ZG (pyocd.core.exceptions.DebugError: No cores were discovered!)

[JohnnyK (Jan Kamidra)]

Hello,

I not sure but I think the situation is still same

DEBUG on target NUCLEO-F746ZG

Impossible to start debug session. I can upload and run, that’s working, but I cannot debug any project. Regards, Raise following error: Selected port 50001 for debugging 0000638:INFO:board:Target type is stm32f746zg 0000646:INFO:coresight_target:Asserting reset prior to connect 0000654:INFO:dap:DP IDR = 0x5ba02477 (v2 rev5) 0000674:INFO:ap:AP#0 IDR = 0x74770001 (AHB-AP var0 rev7) 0000696:INFO:rom_table:AP#0 ROM table #0 @ 0xe00fd000 (designer=020 part=449) 0000703:INFO:rom_table:[0] …

BR, Jan